Hướng dẫn Flash công tắc tuya để sử dụng cho Apple Homekit

Hướng dẫn Flash công tắc tuya để sử dụng cho Apple Homekit

Compatible Devices

This Software is currently tested on: Tuya 3CH

Installation Instructions

Flash the Tuya

  1. Unplug your Tuya from the power line
  2. Connect your Tuya to a serial adapter TTL FT232, connect GND to GPIO 0 and Connect TTL FT232 to USB port on your computer.
Tuya TYWE3STTL
TX RX
RX TX
GPIO0 GND
GND GND
VCC VCC

*** NOTE: Use Power 3.3v to flash

  1. Download firmware
  2. Run the ESP8266Flasher.exe Config as image below and Click Flash button.

5. Flash success. Connect Tuya to power.

Add Tuya to Home app

  1. Connect your iPhone or iPad to the new wifi network Tuya-xxxxxx
  2. If not found Tuya-xxxxxx then long press switch button 10s to reset and try again.
  3. Wait for the Apple Captive Portal and select your WiFi network
  4. Choose and insert your WiFi Password and click Join button (Tuya and Mobile must connect same wifi)
  5. Open the Home app
  6. Click the + symbol
  7. Click I don't have the code...
  8. Select the Tuya-xxxxxxxxxx Switch
  9. If the Tuya-xxxxxxxxxx does not appear on top of the page try to press the Tuya button a 10s, kill the Home App and try from step 4.
  10. Confirm that you want to add the Tuya
  11. Insert the Password that is 12345678 or comment your devices with mac address string, i will reply your comment with correct password.

77 Comments

Leave a Reply

* Name:
* E-mail: (Not Published)
   Website: (Site url withhttp://)
* Comment:
Type Code